Search
Now showing items 1-10 of 19
Comparison on losses and flux distribution between two of 3 phase distribution transformer core 3000 kVA assembled with different angle of T-Joint
(Malaysia - Japan University Center (MJUC), 2007-11-15)
Thia paper describes the results of an investigation on the effect of the use of different angle of T-Joint in two models of 3 phase distribution transformer with capacity of 3000 kVA. The first model uses 3 phase distribution ...
Design guidelines for recycling of rotating machines
(International Association of Science and Technology for Development (IASTED), 2007-04-04)
This paper describes the design guidelines of the rotating machine based on recycling. This explain the detail description of the rotating machine parts how to reuse. Technological issues arising from the following rotating ...
Comparison on losses and flux distribution among the three of 3 phase distribution transformer 1000kVA assembled from various amount of layer of transformer core lamination
(Universiti Kuala Lumpur (UniKL), 2007-12-13)
This paper describes the results of an investigation on the effect of different amount of layer of core lamination in three of 3 phase distribution transformers 1000kVA. The investigation involves the varian of power loss, ...
Comparison on losses and flux distribution among three 3-phase distribution transformers 1000kVA assembled from various amount of layers per stack of transformers core lamination
(Universiti Kuala Lumpur (UniKL), 2007-12-13)
This paper describes the results of an investigarion on the effect of different amount of layers per stack of core lamination in the three of 3 phase distribution transformers 1000kVA. The investigation involves the variant ...
K-factor due to implementing of DC unbalanced/balanced of a transformer
(Institute of Electrical and Electronics Engineers (IEEE), 2007-12-04)
This paper presents the effects of harmonic distortion on loaded single phase two winding transformer.The impact on K-factor is studied by implementing DC unbalanced and balanced configurations. The measurements are done ...
Diagnosis of MV oil filled cable terminations with X-ray imaging and infrared (IR) thermography
(Science Publications, 2007)
A main purpose of doing a diagnostic in cable system including its accessories such as impregnated paper insulated oil filled cable termination is to predict failure before they occur. Those cable and accessories, which ...
Different clamp stress impact on losses and flux distribution between two of 3 phase distribution transformer 1000 kVA assembled with stagger yoke of transformer core lamination
(Institute of Electrical and Electronics Engineers (IEEE), 2007-11-25)
The power loss of transformer core are depends on a large extent on mechanical stress. This paper describes the result of an investigation on effect different clamp stress of core lamination in the two of 3 phase distribution ...
Magnetic levitation system
(Universiti Malaysia Perlis, 2007-05)
Magnetic Levitation (Maglev) Systems have gained considerable interest due to their great practical importance in many engineering fields. Maglev technology has been receiving increasing attention because it helps eliminate ...
Comparison between state feedback and variable structure control of Magnetically Suspended Balance Beam (MSBB) system
(Universiti Teknologi Malaysia (UTM), 2007-05-29)
This paper presents the control of Magnetically Suspended Balance Beam (MSBB)system using Integral Sliding Mode Control (ISMC). The MSBB is a balancing system that use two magnetic coils to balance the beam. The use of ...
Voltage sag and the sensitive load
(Universiti Malaysia Sarawak (UNIMAS), 2007-12-28)
Voltage sag is the important factor in power quality problem faced by many industrial consumers. The most frequently reported among various types of power quality disturbance are voltages sags. The disturbance will cause ...