Search
Now showing items 1-5 of 5
A comparative study of solder properties of Sn-0.7Cu lead-free solder fabricated via the powder metallurgy and casting methods
(Syscom 18 SRL, 2013-07)
The properties of Sn-0.7Cu solder bulk prepared via the powder metallurgy (PM) method were investigated and compared with solder bulk fabricated through casting. Distinct microstructures were observed in both PM and casting ...
Microstructure and interface analysis of glass particulate reinforced aluminum matrix composite
(Trans Tech Publications (TTP), 2013)
A characterization of microstructure and interface was made on the composites Al- 4% Cu reinforced with 15 wt. % glass particulate. The composite was fabricated by powder metallurgy followed by solution treatment and ...
Characteristics of Fe-yttria composites fabricated by powder metallurgy method
(Trans Tech Publications, 2013)
This study is focused on fabricating and characterizing iron (Fe) composites prepared by powder metallurgy route reinforced with varying weight of Yttria (Y2O3). Composites were prepared based on 5 wt. % to 15 wt. % of ...
The effects of Fe additions on the liquid phase sintering of W- bronze composites
(Elsevier BV, 2009)
In this investigation, experiments were conducted to evaluate the effects of Fe additives in the range of 1-5 wt.% on the densification of different compositions of W-pre-alloy bronze compacts sintered isothermally at ...
Microstructure characterization of Al/Calcined Dolomite Metal Matrix Composites
(Universiti Malaysia Perlis (UniMAP), 2007-06-09)
Al/calcined dolomite metal-matrix composites (MMC) were fabricated and tested by varies the calcined dolomite content (10-30 wt%) and using unidirection compaction and sintering as consolidation method. Upon incorporation ...