Search
Now showing items 1-6 of 6
The comparison between four PLCC packages and eight PLCC packages in personal computer (PC) using computational fluid dynamic (CFD), fluent software™ using epoxy moulding compound material (EMC)
(Trans Tech Publications, 2013)
The paper present the three dimensional numerical analysis of heat and fluid flow through Plastic Leaded Chip Carrier (PLCC) packages in inline orientation horizontally mounted on a printed circuit board in a wind tunnel ...
The effect of gap between plastic leaded chip carrier (PLCC) using computational fluid dynamic (CFD) software, FLUENT™
(AENSI Publisher All rights reserved, 2013-10)
This paper presents the effect of gap between Plastic Leaded Chip Carrier (PLCC) by using three dimensional numerical analysis of heat and fluid flow in computer. 3D model of microprocessors is built using GAMBIT and ...
Numerical investigation of heat transfer of twelve Plastic Leaded Chip Carrier (PLCC) by using computational fluid dynamic, FLUENT™ software
(Trans Tech Publications, 2013)
Plastic Leaded Chip Carrier (PLCC) package has been emerged a promising option to tackle the thermal management issue of micro-electronic devices. In the present study, three dimensional numerical analysis of heat and fluid ...
Development of nano-material (nano-silver) in electronic components application
(AENSI Publisher All rights reserved, 2013-10)
This paper presents the development of nano-material in electronic components especially in Plastic Leaded Chip Carrier (PLCC) application. The effect of nano-material in Plastic Leaded Chip Carrier (PLCC)will improve ...
Three dimensional simulation of thermal pad using nanomaterial, nano-silver in semiconductor and electronic component application
(Trans Tech Publications, 2013)
Thermal pad is new technology in this world that been used in PLCC in order to reduce junction temperature to the minimum level in electronic components. In electronic industry, the electronic components that exceed 70°C ...
Machining performance of reinforced alumina insert in end milling of AISI 1018 steel
(Trans Tech Publications, 2013-09)
The main goal of this work is to investigate the performance of zirconia toughened alumina (ZTA) and ZTA reinforced with magnesium oxide (MgO) used as cutting insert in end milling of AISI 1018 steel with hardness of 27 ...