Browsing Researchers by Author "dina@unimap.edu.my"

Now showing items 1-8 of 8

    • Analysis flux on transformer core lamination assembled with mix between 60o- 45o T-joint using 2DFEM 

      Dina Maizana, Maiz Ahmad; Ismail, Daut, Prof. Dr.; Fijay, Fauzi (Universiti Malaysia Perlis (UniMAP)Institut Matematik Kejuruteraan, 2010-06-02)
      This paper describes analysis 2DFEM on 100kVA 3phase distribution transformer assembled with mix between 60-45 T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The simulation involves the ...

    • Effect different limb of transformer core assemble on performance 

      Dina Maizana, Maiz Ahmad, Ir.; Mohd Afif, Mohd Radzi; Nuriziani, Hussin (Trans Tech Publications, 2014)
      This paper described the performance of transformer affected by different limb assembling. The experiment that used to investigate core is no-load, short circuit and load test to find the core loss, copper loss, flux leakage ...

    • Effect of rubber material clamp on core loss of 3-phase 100 kVA transformer core 

      Dina Maizana, Maiz Ahmad, Ir. (Asian Network for Scientific Information, 2013)
      This study describes the result of an investigation on the effect of rubber material clamp of core lamination with stagger yoke on three 100 kVA three-phase distribution transformer. The investigation involves the variation ...

    • Effect of stack of transformer core lamination on losses and flux distribution in 3-phase distribution transformers 1000kVa 

      Ismail, Daut; Dina Maziana, Maiz Ahmad; Shuhaimi, Zakaria; Soib, Taib (Universiti Malaysia Perlis, 2008)
      This paper describes the results of an investigation on the effect of different amount of layers per stack of core lamination in the three of 3-phase distribution transformers 1000kVA. The investigation involves the variation ...

    • Flux pattern in 1000 kVA 11/.433 kV distribution transformer core to sinusoidal wave 

      Shahanom, Uthman; Ismail, Daut, Prof. Dr.; Dina Maizana, Maiz Ahmad, Ir. (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      A study was conducted using sinusoidal waveform to capture flux pattern in CRGO M5 material in a 1000kVA 11kV 3 phase transformer core. It is found that it takes about 180⁰ electrical degree cycle for a pool of flux ...

    • Flux simulation on 100kVA three-phase transformer core 

      Dina Maizana, Maiz Ahmad, Ir.; Ismail, Daut, Prof. Dr.; Soib, Taib (Praise Worthy Prize S.r.l., 2010-06)
      This paper describes the simulation of flux distribution on 100kVA 3 phase distribution transformer assembled with 60°-45° T-joint and mitred lap corner joint with stagger yoke and limb. The core that being used is 3% ...

    • In-plane flux distribution in the mix 60o- 45o T-joint of three phase transformer core 

      Dina Maizana, Maiz Ahmad; Ismail, Daut, Prof. Dr.; Rosnazri, Ali; Risnidar Chan Bahaudin, Ir.; Muhammad Irwanto (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper describes the result of measurement of inplane flux distribution on 100kVA 3phase distribution transformer assembled with the mix 60o- 45o T-joint and mitred lap corner joint with stagger yoke of 10mm. ...

    • Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint 

      Dina Maizana, Maiz Ahmad; Ismail, Daut, Prof. Dr.; Rosnazri, Ali; Syafruddin, Hassan; Risnidar Chan Bahaudin, Ir. (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper describes the result of simulation of flux distribution on 100kVA 3phase distribution transformer assembled with 23o T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The ...