Search
Now showing items 1-9 of 9
Performance evaluation of three phase induction motor using rotor frame 0.35 mm and 0.50 mm of non-oriented steel sheets
(Universiti Malaysia Perlis (UniMAP), 2012)
In this project, the three phase AC induction motor have been thoroughly investigated and analyzed in terms of the induction motor parameter, efficiency, power factor and loss
segregation. Throughout this project, the ...
Hybrid solar and grid-connected system with multi-mode operations
(Universiti Malaysia Perlis (UniMAP), 2012)
Solar energy is beginning to take place as the most important alternative energy source in replacing conventional fuels such as crude oil, coal and natural gas. This is due to the
increasing of energy demand in which ...
Transformerless photovoltaic inverter for photovoltaic power generation in Perlis to run high AC load
(Universiti Malaysia Perlis (UniMAP), 2012)
This thesis presents the transformerless photovoltaic (PV) inverter for PV power generation in Perlis to run high AC load. This study involves the data collection of solar radiation and temperature. The data of solar ...
Development of an active cooling mechanism to increase the efficiency of photovoltaic module
(Universiti Malaysia Perlis (UniMAP), 2012)
In this thesis, the influence of the temperature of photovoltaic (PV) module on the energy conversion efficiency have been thoroughly investigated and analysed. The objectives of this research are to study the suitability ...
The effect of lamination thickness of transformer core on the flux and power loss distribution using grain-oriented 3.1% silicon iron
(Universiti Malaysia Perlis (UniMAP), 2012)
In this project, the 100kVA three phase transformer core model have been investigated and analyzed for its losses and flux distribution using different thickness lamination of the core built with grain-oriented silicon ...
The effect of different stator slot size on flux and losses distribution in 0.5 hp induction motor
(Universiti Malaysia Perlis (UniMAP), 2012)
A study of stator slot design is conducted for induction motor in order to improve the
efficiency and reduce the losses. In this thesis, the effect of different stator slot size on
the flux and losses distribution in 0.5 ...
Design and Development of DC to AC Inverter
(Multimedia University, 2012-07)
This thesis describes the design and construction of a Single Phase Full Bridge Inverter with Sinusoidal Pulse Width Modulated (SPWM) switching scheme. The design of inverter consists of four parts which are control circuit, ...
Effect of rotor bar size on three phase induction motor performance
(Universiti Malaysia Perlis (UniMAP), 2012)
This investigation is to determine the effect of rotor bar size to performance of three phase induction motor. The research was conducted in two forms, namely by using the FEM software and laboratory experiments that ...
An implementation of controller and observer for pittman 8692 brush dc motor
(Universiti Malaya (UM), 2012)
The project focused on DC motor position control system. The main objective is to implement controller and observer for Pittman 8692 rush DC motor, where several controller designs with state-space approaches have been ...