Browsing School of Computer and Communication Engineering (FYP) by Subject "Signal processing"

Now showing items 1-8 of 8

    • 7-input honeycomb sensor by using FPGA application 

      Lem Biing Lin (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      This project is to design a set of light sensors to measure the light intensity and display the sensor that has the highest intensity by using LCD. These light sensors (7 light sensors) are mounted in a honeycomb and each ...

    • Design and development of Ultra Wideband (UWB) wireless transmission using Simulink 

      S.Sharmila A/P Sambasivam (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      Ultra-wideband (UWB) technology is ideal for portable multimedia devices because of its inherent low power consumption, short range, high data rates of up to 480 Mbps and large spatial capacity. Furthermore, the power is ...

    • Design of multiple stop-band filter for interference suppression in UWB applications 

      Leow Chai Ling (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      This is a project describes about the design and fabrication of multiple-stop band filters which will suppress interfering signals in UWB applications. In this project, it is established that complementary split-ring ...

    • FM telephone transmitter 

      Jufri Hj Johari (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2007-04)
      The project titled FM Radio Telephone Transmitter is a project, which consists of telephone set, transmitter electronic circuit, FM Radio where the Standard FM broadcasts are based in the 90 - 95 MHz range. Roughly this ...

    • Implementation Numerical Controlled Oscillator(NCO) for Digital Down Converter (DDC) 

      Husni Diyana, Sarbini (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      In this modern era, most of the signal processing tasks in wireless communications systems are performed digitally. The use of digital signal processing are greatly increasing in digital modulator and demodulator applications. ...

    • Simulate MIMO channel capacity 

      Mohd Aimaduddin, Mohd Ariffin (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      MIMO is defined as Multiple Input Multiple Output systems have multiple antennas at both links at transmitter and receiver. Based on the research that has been done for this project, MIMO system has the capability to ...

    • Simulation of Orthogonal Frequency Division Multiplexing (OFDM) signaling 

      Mastura, Ibrahim (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      The increasing demand on high bit rate and reliable wireless system has led to many new emerging modulation techniques. One of the techniques will be Orthogonal Frequency Division Multiplexing (OFDM), which is combination ...

    • A study of accuracy using Novatel Flexpak GPS receiver 

      Abdul Rahman, Hamdan (Universiti Malaysia PerlisSchool of Computer and Communication Engineering, 2008-04)
      Global Positioning System (GPS) allows properly equipped users to determine their position based on the measured pseudoranges to at least four satellites. By analyzing signals from the satellites, a receiver on the surface ...