Browsing by Subject "Wear"
Now showing items 1-6 of 6
-
Dry sliding wear and compressive strength of Fe-Cr matrix composite with and without Al2O3 reinforcement
(IEEE Conference Publications, 2011)Fe-Cr matrix composites reinforced with Al2O3 particulates fabricated by powder metallurgy (PM) method offer potential for cheaper wear resistance materials and high temperature application. The influence of Al2O3 amount ... -
Effect of roughness of hypo-and hyper-eutectic Al-Si piston alloy on wear characteristics under lubrication
(Malaysian Technical Universities Network (MTUN), 2012-11-20)The tribological behavior of tow AlSi alloys under the influence of surface roughness average was investigated for the present study. The silicon content of these alloys ranged 10 and 16-wt% Si, and includes hypoeutectic ... -
Effect of roughness of hypo-and hyper-eutectic Al-Si piston alloy on wear characteristics under lubrication
(Elsevier B.V., 2013)The tribological behavior of tow Al-Si alloys under the influence of surface roughness average was investigated for the present study. The silicon content of these alloys ranged 10 and 16-wt% Si, and includes hypoeutectic ... -
Preliminary design and development of dry wear tester - pin on disc jigs
(Universiti Malaysia Perlis (UniMAP), 2016-05)Polishing and Grinding process are the important process in the Powder Metallurgy. The purposes of this test are to study about the wear rate, mass of material removal rate and the character of the material that used. ... -
Repair of screw press using hardfacing process
(The Institution of Engineers, Malaysia (IEM), 2015-06) -
Study of wear on anodised PM Aluminium Matrix composite reinforced with 15 wt % Saffil Alumina Short Fibre
(Universiti Malaysia Perlis, 2007-06-09)A study of wear behaviour on anodised powder metallurgy aluminium matrix composites (PM AMC) reinforced with Saffil™ alumina short fibres was done. AMC was fabricated by powder metallurgy methods (PM) with using Al flake ...