Browsing by Subject "Strength"
Now showing items 1-18 of 18
-
Acoustic emission monitoring of multiaxial ultimate elastic wall stress tests of glass fibre-reinforced epoxy composite pipes
(Taylor & Francis, 2014-01)This paper describes the acoustic emission (AE) monitoring of multiaxial ultimate elastic wall stress (UEWS) tests of filament wound glass fibre-reinforced epoxy composite pipes under hydrostatic, pure axial and pure hoop ... -
Bursa Malaysia, ringgit gain strength after OPR cut
(New Straits Times, 2016-07-14) -
Comparing Periodised Protocols for the Maintenance of Strength and Power in Resistance-trained Women
(Kementerian Pendidikan Tinggi (KPT), Malaysia, 2017)Purpose: The purpose of the study was to compare the effects of daily undulating periodisation (DUP) and session undulating periodisation (SUP) for maintaining strength and power over a 3-wk period in a group of ... -
Comparison of Different Exercise Modalities In Improving Metabolic Syndrome Risk Factors Among Obese Females
(Kementerian Pendidikan Tinggi (KPT), Malaysia, 2018)There is compelling evidence of an obesity phenomenon worldwide and interest in structured physical activity in improvement on overall health. Moderate to high levels of cardiorespiratory fitness and muscular strength ... -
The determination of optimum ratio by using recycled concrete aggregate and crumb rubber as partial sand replacement material in sand cement brick production
(Universiti Malaysia Perlis (UniMAP), 2021-08)During the last decades, it has been recognizing that a large volume of waste with growing concerned that wastes from construction and demolition (C&D) are increasing years by years. Most waste materials are left as a ... -
Dry sliding wear and compressive strength of Fe-Cr matrix composite with and without Al2O3 reinforcement
(IEEE Conference Publications, 2011)Fe-Cr matrix composites reinforced with Al2O3 particulates fabricated by powder metallurgy (PM) method offer potential for cheaper wear resistance materials and high temperature application. The influence of Al2O3 amount ... -
Effect of curing regimes on metakaolin geopolymer pastes produced from geopolymer powder
(Scientific.Net/Trans Tech Publications, 2012-12)The properties of metakaolin geopolymer paste are affected by the alkali concentration, the initial raw materials, solidification process, and amount of mixing water as well as the curing conditions. This study aimed to ... -
Effect of fly ash/alkaline activator ratio and sodium silicate/NaoH ratio on fly ash geopolymer coating strength
(Trans Tech Publications, 2013)Fly ash geopolymer coating material potential used to protect surface used in exposure conditions. Ratio of fly ash/alkaline activator and Na₂SiO₃/NaOH play important parameter on determining the best flexural strength of ... -
The influence of 71Ag-28Cu-1Mg filler alloy on microstructure and properties of spot brazed Titanium/Nickel joint
(Universiti Malaysia Perlis, 2009-12-01)The shear strength and microstructural characteristics of titanium-nickel joints joined by spot brazing technique was investigated in this work. The spot brazing process was performed with and without addition of 71Ag-28Cu-1Mg ... -
Influence of dolomite on the mechanical properties of boiler ash geopolymer paste
(Trans Tech Publications, 2014)The waste material from palm oil industry has been increasing since Malaysia was the world largest exported of palm oil mill. The waste such as palm fibers, nut shells, palm kernel and empty fruit bunches are the solid ... -
Optimisation of Shrinkage and Strength on Thick Plate Part Using Recycled LDPE Materials
(MDPI AG, 2021-04-05)Achieving good quality of products from plastic injection moulding processes is very challenging, since the process comprises many affecting parameters. Common defects such as warpage are hard to avoid, and the defective ... -
The past, present & future of concrete construction
(The Institution of Engineers, Malaysia (IEM), 2021)Concrete has always been the major construction material since the historical past, at present and will continue into the future. This presentation covers the period from the first UK design code (CP 114, 1957) in UK to ... -
Ringgit poised to strengthen further
(New Straits Times, 2018-01-12) -
Rising ringgit
(The Star, 2017-09-08) -
Strength and deformation characteristics of cement treated soft Bangladesh clays
(Institution of Engineers, Malaysia (IEM), 2011-12)The strength and deformation characteristics of cement treated soft Bangladesh clays are evaluated through a series of experimental investigations. Based on the rate of strength development, the unconfined compressive ... -
Strength, density and water absoprtion of Palm oil boiler ash (POBA) geopolymer brick/IBS brick
(Trans Tech Publications Ltd., 2016-01)Geopolymer or alkali-activated binder is produced by synthesizing aluminosilicate source materials with an alkaline activator solution. This study has been conducted to produce palm oil boiler ash (POBA) geopolymer brick/IBS ... -
Stronger ringgit benefits auto firms
(New Straits Times, 2017-09-22) -
Study on the different arrangement of brick masonry wall between three type of bricks
(Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2013-06)This project presents the result of brick masonry strength depends on different bonding follow by the type brick and to determine the crack pattern at the masonry wall. The arrangement was used in this research is stretcher ...