Browsing by Subject "Finite element"
Now showing items 1-9 of 9
-
Dynamic axial crushing of empty and foam-filled conical aluminium tubes: Experimental and numerical analysis
(Trans Tech Publications, 2014-09)This paper presents the crushing behaviour of empty and foam-filled conical tubes under axial dynamic loading. A nonlinear finite element (FE) model was developed and validated against experiments. The validated model was ... -
Effect of filler on the impact characteristics of aluminium tubes
(Taylor & Francis, 2014-12-18)This paper presents the behaviour of empty and foam-filled aluminium alloy (AA6061-T6) tubes under dynamic axial loading. The influence of geometrical and various densities of fillers was investigated by employing a finite ... -
Electromagnetic torque performance evaluation of concentric magnetic gear alternative conditions using finite element
(Universiti Malaysia Perlis (UniMAP), 2021-08)Concentric magnetic gear(CMG) research mainly focuses on the CMG act as torque increaser and with stationary pole piece condition. Yet, technically CMG can be designed as speed increaser gear with the alternative rotating ... -
An experimental and numerical analysis of empty and foam-filled aluminium conical tubes under oblique impact loading
(Trans Tech Publications, 2013)This paper presents the crushing behaviour of empty and foam-filled conical aluminium alloy (AA6061-T6) tubes under oblique impact loading using a validated nonlinear finite element (FE) code, LS-DYNA. The study aims to ... -
Experimental and numerical analysis of foam-filled aluminum conical tubes subjected to oblique impact loading
(Carl Hanser Verlag GmbH & Co. KG., 2014)This study aims to investigate the response of AA6061-T6 conical tubes under oblique impact loading, for variations in filler density and tube material by using experimentally validated model. Good correlations between the ... -
Flux simulation on 100kVA three-phase transformer core
(Praise Worthy Prize S.r.l., 2010-06)This paper describes the simulation of flux distribution on 100kVA 3 phase distribution transformer assembled with 60°-45° T-joint and mitred lap corner joint with stagger yoke and limb. The core that being used is 3% ... -
Simulation of the distributed rainfall-runoff process
(The Institution of Engineers, Malaysia, 2004-03)A deterministic model to simulate rainfall runoff from pervious and impervious surfaces is presented. The surface runoff model is based on an established one-dimensional, variable width, kinematics wave approximation to ... -
Stress analysis and failure characterizations of v-shaped epoxy adhesively bonded joint
(Universiti Malaysia Perlis (UniMAP), 2013-03-26)This paper deals with stress and failure characteristics of V-shaped epoxy adhesive joint. Effect of scarf angle upon failure morphology was investigated by tensile test and monitoring using high speed camera. V-shaped ... -
Stress analysis and failure characterizations of V-shaped epoxy adhesively bonded joint
(Trans Tech Publications, 2013)This paper deals with stress and failure characteristics of V-shaped epoxy adhesive joint. Effect of scarf angle upon failure morphology was investigated by tensile test and monitoring using high speed camera. V-shaped ...