Browsing by Subject "Cutting tool"
Now showing items 1-4 of 4
-
Investigation of dimensional accuracy and chip formation on peck drilling of mild steel
(Universiti Malaysia Perlis (UniMAP), 2016-05)Drilling process is the most important machining process in the manufacturing industries. Almost all mild steel industries and production are based on drilling process. However, the difficulty of the mild steel machining ... -
Investigation of tool wear and chip formation on through hole drilling of mild steel
(Universiti Malaysia Perlis (UniMAP), 2016-05)Nowadays, the problem of cutting tool failures becomes important in manufacturing industries. After certain working time at production, tool wear occurs and cutting tool become dull and required a changing. This is because ... -
Microstructure, mechanical properties and cutting performance of sintered sub-micron WC-Co hardmetal powder
(Universiti Malaysia Perlis, 2009-12-01)The microstructure and mechanical properties of sintered 94WC-6Co hardmetal powders were investigated. In this work, sub-micron (< 1m) of tungsten carbide (WC), cobalt (Co) and paraffin wax powders were wet mixing in a ... -
Thermal study of cutting tool in turning process
(Universiti Malaysia Perlis (UniMAP), 2015-12)During the turning process, heat in generated at the edge of cutting tool. This heat is then dissipated through 4 parameter that is cutting tool, work piece, the chipped formed and the cutting fluid. In this experiment, ...