Please use this identifier to cite or link to this item:
http://dspace.unimap.edu.my:80/xmlui/handle/123456789/37114
Full metadata record
DC Field | Value | Language |
---|---|---|
dc.contributor.author | Syed Abdul Malek, Syed Adanan | - |
dc.date.accessioned | 2014-09-12T07:04:49Z | - |
dc.date.available | 2014-09-12T07:04:49Z | - |
dc.date.issued | 2010-04 | - |
dc.identifier.uri | http://dspace.unimap.edu.my:80/dspace/handle/123456789/37114 | - |
dc.description | Access is limited to UniMAP community. | en_US |
dc.description.abstract | Study of Machining Parameter of Wire Electrical Discharge of Nickel-Base Alloys using Response Surface Method (RSM) had been done in this project. WEDM machine that use for this project is SODICK AQ327L that located at Automart Teaching Factory, Kuala Perlis. The WEDM machine process is a consequence electrical field produced when two electrodes subjected to a voltage and submerged in a dielectric fluid, positive ions and electrons are accelerated, producing a discharge channel that become conductive. Then, firstly is to measure Material Removal Rate (MRR) and Surface Roughness (Ra) using the values that obtained from experiment. The cutting parameter is Voltage (V), Peak Current (A), Wire Speed (mm/min) and Wire Tension (N) to cutting the provided material. Secondly, model that to measured maximize MRR and minimize Surface Roughness (Ra) will be analyze using Design Expert Software by Response Surface Method. Comparison of calculated and measured value of maximum and minimum allowed us to obtain the efficiency of WEDM system for cutting process. Confirmation test have been done to confirm the value that predicted using Design Expert Software. The confirmation test for MRR and Ra was using by the setting of Voltage 4.0 V, Peak Current 6.0 A, Wire Speed 110 mm/min and Wire Tension 160 N. The MRR value that obtained from experimental result for MRR was 0.11 mm³/sec and for Ra was 2.236 µm. Error within 10% was allowed. | en_US |
dc.language.iso | en | en_US |
dc.publisher | Universiti Malaysia Perlis (UniMAP) | en_US |
dc.subject | Machining parameter | en_US |
dc.subject | Response Surface Method (RSM) | en_US |
dc.subject | Surface roughness | en_US |
dc.subject | Electric metal-cutting | en_US |
dc.title | Study of machining parameter of wire electrical discharge of nickel-base alloys using response surface method | en_US |
dc.type | Learning Object | en_US |
dc.contributor.advisor | Rozie Nani Haji Ahmad | en_US |
dc.publisher.department | School of Manufacturing Engineering | en_US |
Appears in Collections: | School of Manufacturing Engineering (FYP) |
Files in This Item:
File | Description | Size | Format | |
---|---|---|---|---|
Abstract, Acknowledgment.pdf | 98.21 kB | Adobe PDF | View/Open | |
Introduction.pdf | 63.16 kB | Adobe PDF | View/Open | |
Literature review.pdf | 244.61 kB | Adobe PDF | View/Open | |
Methodology.pdf | 321.93 kB | Adobe PDF | View/Open | |
Results and discussion.pdf | 476.11 kB | Adobe PDF | View/Open | |
Conclusion.pdf | 58.77 kB | Adobe PDF | View/Open | |
References and appendix.pdf | 1.02 MB | Adobe PDF | View/Open |
Items in UniMAP Library Digital Repository are protected by copyright, with all rights reserved, unless otherwise indicated.