Please use this identifier to cite or link to this item:
http://dspace.unimap.edu.my:80/xmlui/handle/123456789/3315
Full metadata record
DC Field | Value | Language |
---|---|---|
dc.contributor.author | Khairunnisa Omar | - |
dc.date.accessioned | 2008-11-25T06:59:53Z | - |
dc.date.available | 2008-11-25T06:59:53Z | - |
dc.date.issued | 2008-04 | - |
dc.identifier.uri | http://dspace.unimap.edu.my/123456789/3315 | - |
dc.description.abstract | This project involve 3 sample types that had labeled as Premix A (1%Sn addition), Premix B (1.5%Sn addition) and Premix C (2.0%Sn), each types have five samples. After compaction process measured the weight, thickness, width, length, volume, and density. Sintered those samples at 590°C with 5°C/min of heating rate and measure same like during before sintered. Porosity test done by manually measure by weighing samples at three conditions: normal (air), immersed in water and drying after immersed then calculate using formula of porosity. The average result for Premix A is 6% pores, 2.5% pores for Premix B and 3% pores for Premix C. Hardness test had been done by using Macro hardness Vickers. The average result for Premix A is 36.6 HV, 34.8 HV for Premix B and 40.1 HV for Premix C. Finally, observed microstructure using image analyzer with analyzed the grain boundary of microstructure by make samples preparation first. The optimum percent Sn has been determined by compare samples to each test that have done which are conclude by higher hardness and lower % pores. Notice that, Premix C is the optimum values where got 40.1 HV and 3% pores. | en_US |
dc.language.iso | en | en_US |
dc.publisher | Universiti Malaysia Perlis | en_US |
dc.subject | Powder metallurgy | en_US |
dc.subject | Aluminum -- Testing | en_US |
dc.subject | Sintering | en_US |
dc.subject | Sinter (Metallurgy) | en_US |
dc.subject | Aluminum alloys | en_US |
dc.subject | Stannum | en_US |
dc.title | Microstructure of development Al-Mg-Si-Cu powder metallurgy under different addition of Sn | en_US |
dc.type | Learning Object | en_US |
dc.contributor.advisor | Nur Maizatul Shima Adzali (Advisor) | en_US |
dc.publisher.department | School of Materials Engineering | en_US |
Appears in Collections: | School of Materials Engineering (FYP) |
Files in This Item:
File | Description | Size | Format | |
---|---|---|---|---|
References and appendix.pdf | 104.07 kB | Adobe PDF | View/Open | |
Conclusion.pdf | 16.94 kB | Adobe PDF | View/Open | |
Results and discussion.pdf | 1.62 MB | Adobe PDF | View/Open | |
Methodology.pdf | 221.26 kB | Adobe PDF | View/Open | |
Literature review.pdf | 83.38 kB | Adobe PDF | View/Open | |
Introduction.pdf | 18.51 kB | Adobe PDF | View/Open | |
Abstract, Acknowledgement.pdf | 32.3 kB | Adobe PDF | View/Open |
Items in UniMAP Library Digital Repository are protected by copyright, with all rights reserved, unless otherwise indicated.