Please use this identifier to cite or link to this item: http://dspace.unimap.edu.my:80/xmlui/handle/123456789/27721
Full metadata record
DC FieldValueLanguage
dc.contributor.authorCheang, Chee Huang-
dc.date.accessioned2013-08-27T05:10:37Z-
dc.date.available2013-08-27T05:10:37Z-
dc.date.issued2011-05-
dc.identifier.urihttp://dspace.unimap.edu.my/123456789/27721-
dc.descriptionAccess is limited to UniMAP community.en_US
dc.description.abstractThis project discusses the design of charge measurement meter. This instrument was used to measure the rate of charges for different surroundings. Construct a capacitor plate to capture the charge, connect the capacitor plate to capacitor, then connected it to amplifier to enlarge the DC voltage signal. Before that, the amplification of the operational amplifier was tested. The enlarged voltages obtained are then converted back to the original voltage value produced. Finally, the rate of charge was calculated by using the formula. The results obtained shows that the rate of charge at indoor surrounding is higher than outdoor.en_US
dc.language.isoenen_US
dc.publisherUniversiti Malaysia Perlis (UniMAP)en_US
dc.subjectCharge measurement meteren_US
dc.subjectCharge amplifieren_US
dc.subjectCapacitor plateen_US
dc.titleCharge measurement systemen_US
dc.typeLearning Objecten_US
dc.contributor.advisorProf. Dr Syed Idris Syed Hassanen_US
dc.publisher.departmentSchool of Electrical System Engineeringen_US
Appears in Collections:School of Electrical Systems Engineering (FYP)

Files in This Item:
File Description SizeFormat 
Abstract, Acknowledgement.pdf52.7 kBAdobe PDFView/Open
Introduction.pdf29.74 kBAdobe PDFView/Open
Literature review.pdf204.75 kBAdobe PDFView/Open
Methodology.pdf105.34 kBAdobe PDFView/Open
Results and discussion.pdf102.57 kBAdobe PDFView/Open
Conclusion.pdf37.56 kBAdobe PDFView/Open
Reference and appendix.pdf59.27 kBAdobe PDFView/Open


Items in UniMAP Library Digital Repository are protected by copyright, with all rights reserved, unless otherwise indicated.