| dc.contributor.author | Siti Aishah, Adam | |
| dc.contributor.author | Fairuz, M. A | |
| dc.contributor.author | Mohd Sabri, Hussin | |
| dc.contributor.author | Hafiezal, M. R M | |
| dc.contributor.author | Khaironisa, S. N | |
| dc.date.accessioned | 2016-10-21T07:57:00Z | |
| dc.date.available | 2016-10-21T07:57:00Z | |
| dc.date.issued | 2014-01 | |
| dc.identifier.citation | International Review of Mechanical Engineering, vol.8 (1), 2014, pages 22-27 | en_US |
| dc.identifier.issn | 1970-8734 | |
| dc.identifier.issn | 1970-8742 (online) | |
| dc.identifier.uri | http://dspace.unimap.edu.my:80/xmlui/handle/123456789/43757 | |
| dc.description | Link to publisher's homepage at http://www.praiseworthyprize.org | en_US |
| dc.description.abstract | The study was focused on the effect of using Sunflower Oil as a lubricant during turning operation of Stainless Steel. Cutting speed, feed rate and depth of cut were set as the control factor for the machining operation. An Orthogonal Array of L4 (23) was used. Then ANOVA analyses were carried out to identify the significant factors affecting surface roughness, Ra and tool wear, Vb, and determined the optimal cutting combination design by seeking the responses and signal-to-noise ratio. Finally, the confirmations run can optimize the optimal parameters and cutting fluid for surface roughness and tool wear. | en_US |
| dc.language.iso | en | en_US |
| dc.publisher | Praise Worthy Prize | en_US |
| dc.subject | ANOVA | en_US |
| dc.subject | Sunflower oil | en_US |
| dc.subject | Surface roughness | en_US |
| dc.subject | Taguchi method of orthogonal array | en_US |
| dc.subject | Tool wear | en_US |
| dc.title | Investigate the effect of using sunflower oil as a lubricant during turning operation of stainless steel | en_US |
| dc.type | Article | en_US |
| dc.contributor.url | aishahadam@unimap.edu.my | en_US |
