Search
Now showing items 1-5 of 5
Compaction optimization of Sn-Cu-Si3N4via powder metallurgy route for composite solder fabrication
(Trans Tech Publications, 2013)
The aim of this study was to optimize the compaction process of a composite solder fabricated via powder metallurgy route, before details study were conducted in the next stage. Powder of Sn, Cu and Si3N4 were carefully ...
Study on the properties of oil palm trunk fiber (OPTF) in cement composite
(Trans Tech Publications, 2013)
Properties of oil palm trunk fiber reinforced cement composite were investigated in this study. Oil palm trunk fiber was used to improve the properties of cement composite. It was found that increasing in oil palm trunk ...
Study on physical and chemical properties of fly ash from different area in Malaysia
(Trans Tech Publications, 2013-12)
Fly ash is residue from the combustion of coal which widely available in worldwide and lead to waste management proposal. Moreover, the use of fly ash is more environmental friendly and save cost compared to OPC. Fly ash ...
Mechanical properties of ZTA composite using cold isostatic pressing and uniaxial pressing
(Trans Tech Publications, 2013)
Alumina-zirconia composite is an engineering material with a great potential to be develop for application as high temperature resistance structural material. In this research, zirconia toughness alumina (ZTA) was produced ...
Microstructure studies on the effect of the alkaline activators of fly ash-based geopolymer at elevated heat treatment temperature
(Trans Tech Publications, 2013)
Fly ash-based geopolymers are new binding materials produced to replace the ordinary Portland cement (OPC) used in concrete. In this research, the effect of alkaline activators on the compressive strength and the microstructure ...