Browsing Mohd Mustafa Al Bakri Abdullah, Prof. Dr. by Author "Mohd Mustafa, Al Bakri Abdullah"

Now showing items 1-11 of 11

    • Chemical and physical characterization of boiler ash from palm oil industry waste for geopolymer composite 

      Zarina, Yahya; Mohd Mustafa, Al Bakri Abdullah; Kamarudin, Hussin; Khairul Nizar, Ismail; Andrei Victor, Sandu; Petricǎ, Vizureanu; Rafiza, Abdul Razak (Syscom 18 SRL/ SC BIBLIOTECA CHIMIEI SA, 2013-12)
      The characterizations of boiler ash waste from waste of palm oil industry were performed. The boiler ash was obtained from the boiler in the palm oil processing factory. The chemical and physical characterization has been ...

    • Decor Polymer Concrete (DPC) 

      Mohd Mustafa, Al Bakri Abdullah; Che Mohd Ruzaidi, Ghazali, Assoc. Prof.; Kamarudin, Hussin, Prof. Dr.; Norazian, Mohamed Noor; Mohammad Tamizi, Selimin; Norzaidi, Zainol; Rozaimah, Ramly (School of Materials Engineering, 2008-01-09)
      Decorative application. Non-structural. Raw materials from polymer waste such as HOPE, PS, PET and others.

    • Decorative Bagasse Fiber Board 

      Mohd Mustafa, Al Bakri Abdullah; Che Mohd Ruzaidi, Ghazali, Assoc. Prof.; Kamarudin, Hussin, Prof. Dr.; Norazian, Mohamed Noor; Norzaidi, Zainol; Liyana, Jamaludin (School of Materials Engineering, 2008-01-09)
      Use as a colourful panel board or partition panel. Cost saving of raw material and used to replace conventional fiber board. Raw material from waste which is bagasse.

    • The effect of curing temperature on physical and chemical properties of geopolymers 

      Mohd Mustafa, Al Bakri Abdullah; Kamarudin, Hussin; Mohammed Amjad, Hussain; Khairul Nizar, Ismail; Zarina, Yahya; Rafiza, Abdul Razak (Elsevier BV, 2011)
      Fly ash-based geopolymers required heat to increase the geopolymerization process in order to obtain higher compressive strength. As such, geopolymer samples were prepared using different curing temperatures (room temperature, ...

    • Effect of Glass Reinforced Epoxy (GRE) pipe filled with Geopolymer Materials for Piping Application: Compression Properties 

      Mohammad Firdaus, Abu Hashim; Mohd Mustafa, Al Bakri Abdullah; Che Mohd Ruzaidi, Ghazali; Kamarudin, Hussin; Mohammed, Binhussain; Mohd Firdaus, Omar (EDP Sciences, 2016)
      The aim of this paper is to achieve the highest compressive strength of glass reinforced epoxy pipe with the geopolymer filler content of weight percentage that were used in glass reinforced epoxy pipe. The samples were ...

    • Effect of NaOH concentration on microstructure of boiler ash based geopolymer 

      Zarina, Yahya; Mohd Mustafa, Al Bakri Abdullah; Kamarudin, Hussin; Khairul Nizar, Ismail; Abdul Rahim, Abdul Razak (Trans Tech Publications Ltd., 2015)
      Boiler ash is one of the waste material from palm oil processing industry and it was widely available. The role of alkaline activator in geopolymer is important for its mechanical properties. NaOH and sodium silicate ...

    • Estimation of missing values for air pollution data using Interpolation technique 

      Norazian, Mohamed Noor; Mohd Mustafa, Al Bakri Abdullah; Ahmad Shukri, Yahaya; Nor Azam, Ramli (Universiti Malaysia Perlis, 2006)
      Air pollution data such as PM10, sulphur dioxide, ozone and carbon monoxide are usually obtained using automated machines located at different sites. These are usually due to mechanical failure, routine maintenance, changes ...

    • High Strength K-Brick: Rapid Set Brick 

      Mohd Mustafa, Al Bakri Abdullah; Mohammad Tamizi, Selimin; Che Mohd Ruzaidi, Ghazali, Assoc. Prof.; Kamarudin, Hussin, Prof. Dr.; Norazian, Mohamed Noor; Mohd Nasir, Ibrahim; Norzaidi, Zainol (School of Materials Engineering, 2008-01-09)

    • Modelling of PM 10 concentration for industrialized area in Malaysia: A case study in Shah Alam 

      Norazian, Mohamed Noor; Mohd Mustafa, Al Bakri Abdullah; Tan, Cheng Yau; Nor Azam, Ramli; Ahmad Shukri, Yahaya; Noor Faizah Fitri, Md. Yusof (Elsevier BV, 2011)
      In Malaysia, the predominant air pollutants are suspended particulate matter (SPM) and nitrogen dioxide (NO 2). This research is on PM 10 as they may trigger harm to human health as well as environment. Six distributions, ...

    • Preliminary study on concrete with polystyrene waste coarse aggregate 

      Mohd Mustafa, Al Bakri Abdullah; Che Mohd Ruzaidi, Ghazali; Norazian, Mohamed Noor; Kamarudin, Hussin; Abu Bakar, Mohamad Diah; Mohd Tajuddin, Mohd Idris (Construction Industry Development Board, Malaysia (CIDB), Construction Research Institute of Malaysia (CREAM) & Universiti Teknologi MARA (UiTM), 2007-03-14)
      Polymer recycling has received a great deal of attention in this recent year. Presently, small percentage of polymer wastes in Malaysia has been under going the recycling process. This recycling process has typically been ...

    • The relationship of NaOH molarity, Na2SiO3/NaOH ratio, fly ash/alkaline activator ratio, and curing temperature to the strength of fly ash-based geopolymer 

      Mohd Mustafa, Al Bakri Abdullah; Kamarudin, Hussin; Mohammed Amjad, Hussin; Khairul Nizar, Ismail; Rafiza, Abdul Razak; Zarina, Yahya (Trans Tech Publications, 2011)
      Geopolymer, produced by the reaction of fly ash with an alkaline activator (mixture of Na2SiO3 and NaOH solutions), is an alternative to the use of ordinary Portland cement (OPC) in the construction industry. However, there ...