Ismail Daut, Prof. Dr.: Recent submissions

Now showing items 21-40 of 154

    • Harmonic performance of single phase transformer with DC biased 

      Syafruddin, Hasan; Ismail, Daut, Prof. Dr.; Soib, Taib, Prof. Madya Dr.; Dina Maizana, Maiz Ahmad, Ir.; Rosnazri, Ali; Nor Ashbahani, Ashbahani (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      Direct current (DC) flowing through the earthed neutrals of transformer windings causes a DC component in magnetizing current. Owing to nonlinearity, the waveform of this current is strongly distorted. A high enough ...

    • Wavelet based distortion measurement and enhancement of ECG signal 

      Md. Abdul, Awal; Mohiuddin, Ahmad, Prof. Dr. Engr.; Ismail, Daut, Prof. Dr.; Ernie, Che Mid; Mohd. Abdur, Rashid, Dr. (Institute of Electrical and Electronics Engineers (IEEE), 2012-02-27)
      This paper describes the research carried out to eliminate the noise found in ECG signal and cardiac rhythm using Coiflet wavelet since its scaling function is closely related to the shape of ECG and suited for denoising ...

    • Performance comparison different thickness of non oriented electrical steel material using analysis and performance chart from FEM software 

      Yanawati, Yahya; Ismail, Daut, Prof. Dr.; Nair, Gomesh; Nor Shafiqin, Shariffuddin; Pungut, Ibrahim; M., Abdullah (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      With market condition today, the economics are such that users and engineer are looking for the best fit for the application at the most reasonable cost in purchasing induction motors. Generally, 0.35mm thickness of ...

    • Induction motor behavior due to unsymmetrical and symmetrical faults 

      Surya, Hardi; Ismail, Daut, Prof. Dr.; Risnidar Chan Bahaudin; Muhammad Irwanto; Rosnazri, Ali; Indra, Nisja (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      Voltage sags are generally caused by faults on transmission and/or distribution systems. The voltage produced may be either unsymmetrical or symmetrical, depend on type of faults. Unsymmetrical fault is faults caused by ...

    • Design and sizing photovoltaic system for DC air-conditioning 

      Shatri, C.; Ismail, Daut, Prof. Dr.; Muhammad Irwanto; Noor Syafawati, Ahmad; S. S., Saad; Khairul Anuar, Mohd Nor (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      The author is designing the photovoltaic system to support the DC air-conditioning. There are calculations that have to achieve such as daily load energy (EL), energy directly from sun (Esun), area of photovoltaic ...

    • Flux pattern in 1000 kVA 11/.433 kV distribution transformer core to sinusoidal wave 

      Shahanom, Uthman; Ismail, Daut, Prof. Dr.; Dina Maizana, Maiz Ahmad, Ir. (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      A study was conducted using sinusoidal waveform to capture flux pattern in CRGO M5 material in a 1000kVA 11kV 3 phase transformer core. It is found that it takes about 180⁰ electrical degree cycle for a pool of flux ...

    • Predicting an investigation of flux distribution in three phase induction motor stators by using different stator slot sizes 

      Nor Shafiqin, Shariffuddin; Ismail, Daut, Prof. Dr.; Yanawati, Yahya; Pungut, Ibrahim; M., Abdullah; Nair, Gomesh (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-09-16)
      The predicting of different stator slot sizes on flux distribution in three phase induction motor is presented. For both stator models, the maximum flux density is found near the tooth tip and minimum towards the outer ...

    • The effect of different stator slot size on the stator copper loss 

      Nor Shafiqin, Shariffuddin; Ismail, Daut, Prof. Dr.; Yanawati, Yahya; Pungut, Ibrahim; M., Abdullah; Nair, Gomesh; M., Asri (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      The input power to an induction motor is in the form of three phase electric voltages and currents. The first losses encountered in the machine are I2R losses in the stator winding. The stator copper loss occurs when the ...

    • An alternative approach to solar and grid-connected hybrid electricity for homes and buildings in Malaysia 

      Rosnazri, Ali; Ismail, Daut, Prof. Dr.; Soib, Taib, Prof. Madya Dr.; Muhammad Irwanto, Misrun; Surya, Hardi (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper presents the proposal of a solar and grid-connected hybrid electricity system for homes and also buildings. A new concept of using a DC motor and synchronous generator as an electromechanical inverter is ...

    • Study of photovoltaic and inverter characteristics 

      Saidatul Shema, Saad; Ismail, Daut, Prof. Dr.; Muhammad Irwanto, Misrun; S., Champakeow; N. S., Ahmad (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      The development of renewable energy is increasing worldwide because of the growing demand on energy, high oil prices, and concerns of environmental impacts. Solar energy is amongst the highest development of renewable ...

    • Copper rotor development process of induction motor 

      Ismail, Daut, Prof. Dr.; Anayet, Karim; Mohd Saufi, Ahmad (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper proposes the technique for developing a copper rotor for AC induction motor. A simple substitution of copper for aluminum in the rotor conductor bars will generally provide a significant reduction in I²R ...

    • Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint 

      Dina Maizana, Maiz Ahmad; Ismail, Daut, Prof. Dr.; Rosnazri, Ali; Syafruddin, Hassan; Risnidar Chan Bahaudin, Ir. (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper describes the result of simulation of flux distribution on 100kVA 3phase distribution transformer assembled with 23o T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The ...

    • Effect of solar irradiance and temperature on photovoltaic module electrical characteristics 

      M., Irwanto; Ismail, Daut, Prof. Dr.; Merdang, Sembiring, Dr. Ir.; Rosnazri, Ali; S., Champakeow; S., Shema (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      The electrical characteristics of photovoltaic (PV) module are dependent on solar irradiance and temperature. It consists of short circuit current, open circuit voltage, maximum power, fill factor and efficiency. This ...

    • Loss prediction of induction motor using OPERA 2D software 

      Ismail, Daut, Prof. Dr.; Anayet, Karim; Pungut, Ibrahim; Yanawati, Yahya; Nor Shafiqin, Shariffuddin; Faizal (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      The paper discusses the factors which determine the losses of induction motor. The loss mechanisms are described in this paper and it is related to the performance and design characteristics of induction motor such as ...

    • High side MOSFET driver design using discrete components for low voltage applications 

      Pungut, Ibrahim; Rosnazri, Ali; Ismail, Daut, Prof. Dr.; Soib, Taib, Prof. Madya Dr.; Dina Maizana, Maiz Ahmad; Risnidar Chan Bahaudin, Ir. (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper presents the design of a high-side N-channel MOSFET driver using discrete components for low voltage applications, ranging from 3V up to 24Vdc operation. Special level shifting technique is used to increase the ...

    • In-plane flux distribution in the mix 60o- 45o T-joint of three phase transformer core 

      Dina Maizana, Maiz Ahmad; Ismail, Daut, Prof. Dr.; Rosnazri, Ali; Risnidar Chan Bahaudin, Ir.; Muhammad Irwanto (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper describes the result of measurement of inplane flux distribution on 100kVA 3phase distribution transformer assembled with the mix 60o- 45o T-joint and mitred lap corner joint with stagger yoke of 10mm. ...

    • Investigation of power factor on harmonic effect due to types of voltage source 

      Risnidar Chan Bahaudin, Ir.; Ismail, Daut, Prof. Dr.; Syafruddin, Hassan; M. I., Yussof; Rosnazri, Ali; Dina Maizana, Maiz Ahmad; Indra, Nisja; Masykur (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      This paper discussed about power factor on harmonic effect due to types of voltage source. Usually, the voltage source is sinusoidal. But in actually, the condition of the load is has voltage sources through the elements ...

    • Current transformer reaction with total harmonic distortion 

      Khairul Anuar, Mohd Nor; Ismail, Daut, Prof. Dr.; Indra, Nisja; M., Reza; Nor Ashbahani, Mohamad Kajaan (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      Current transformer (CT) has a critical role in protective and measurement devices used in both the industrial and the utility worlds. However, the used of current transformer in harmonic condition brings some effects ...

    • Investigation of relationships of adjustable speed drive (ASD) and type of voltage source on harmonic characteristics 

      Risnidar Chan Bahaudin, Ir.; Ismail, Daut, Prof. dr.; Surya, Hardi; M. I., Yussof; Rosnazri, Ali; Dina Maizana, Maiz Ahmad; Eddy, Warman; Masykur (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2012-10-16)
      This paper discussed about relationship of ASD and types of voltage source on harmonic characteristics. Usually, the voltage source is sinusoidal. But in actually, the condition of the load is it has voltage sources ...

    • Effect of different size of rotor bars on induction motor efficiency 

      Pungut, Ibrahim; Ismail, Daut, Prof. dr.; Rosnazri, Ali; Yanawati, Yahya; Nor Shafiqin, Shariffuddin; Mastika, Abdullah (Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)
      Efficiency is the main consideration in designing of any equipment. In an induction motor, there are many parameters that could affect the motor efficiency. One of them is the size of rotor bar, that contribute to the rotor ...