Search
Now showing items 11-20 of 43
Investigation of influence of voltage source type on harmonic characteristics
(Institute of Electrical and Electronics Engineers (IEEE), 2010-06-23)
This paper discussed about influence of voltage source types on harmonic characteristics. Usually, the voltage source is sinusoidal. But in actually, the condition of the load is has voltage sources through the elements ...
Testing of contactors under voltage sag and non-sinusoidal voltage conditions
(Institute of Electrical and Electronics Engineers (IEEE), 2010-11-29)
Sensitivity of electromagnetic contactors for voltage sags and non-sinusoidal voltage supply has been carried out by laboratory testing. Effects of sag characteristics such as; sag magnitude, sag duration and point on wave ...
The impacts of stator outside diameters on induction motor nameplates: Analysis by using a finite element
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Design stimulation by software is important in order to save money and time. This paper is using stimulation software, which is a finite element method, to analyze the stator outside diameter impact on rated current, horse ...
The impacts of stator materials on induction motor nameplate parameters for high performance
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Core materials and magnet wire sizes were analyzed in order to find out the impacts on nameplate for high performance motor. Stack length and back core iron depth of stator geometry design are the parameters involve in ...
Performance of photovoltaic module at different tilt angles in Perlis, Northern Malaysia
(Praise Worthy Prize, 2010-12)
This paper presents a calculation of the tilt angles and the solar irradiance on PV module in Perlis, Nortern Malaysia. A mathematical modeling is used to calculate the tilt angles and the solar irradiance, which depend ...
Induction motor behavior due to unsymmetrical and symmetrical faults
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Voltage sags are generally caused by faults on transmission and/or distribution systems. The voltage produced may be either unsymmetrical or symmetrical, depend on type of faults. Unsymmetrical fault is faults caused by ...
Flux simulation on 100kVA three-phase transformer core
(Praise Worthy Prize S.r.l., 2010-06)
This paper describes the simulation of flux distribution on 100kVA 3 phase distribution transformer assembled with 60°-45° T-joint and mitred lap corner joint with stagger yoke and limb. The core that being used is 3% ...
Performance comparison different thickness of non oriented electrical steel material using analysis and performance chart from FEM software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
With market condition today, the economics are
such that users and engineer are looking for the best
fit for the application at the most reasonable cost in
purchasing induction motors. Generally, 0.35mm
thickness of ...
Study of photovoltaic and inverter characteristics
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
The development of renewable energy is
increasing worldwide because of the growing demand
on energy, high oil prices, and concerns of
environmental impacts. Solar energy is amongst the
highest development of renewable ...
High side MOSFET driver design using discrete components for low voltage applications
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents the design of a high-side N-channel MOSFET driver using discrete components for low voltage applications, ranging from 3V up to 24Vdc operation. Special level shifting technique is used to increase the ...