Search
Now showing items 31-40 of 89
Diagnosis of MV oil filled cable terminations with X-ray imaging and infrared (IR) thermography
(Science Publications, 2007)
A main purpose of doing a diagnostic in cable system including its accessories such as impregnated paper insulated oil filled cable termination is to predict failure before they occur. Those cable and accessories, which ...
Performace of wind turbine based on wind speed data and turbine tower height in Kangar, Northern Malaysia
(Australian Journal of Basic and Applied Sciences, 2011-07)
This paper presents an analysis of the wind speed characteristic in Kangar, Northern Malaysia. The Weibull distribution function is applied to analyze the wind speed characteristic and used to calculate the wind power ...
The impacts of stator outside diameters on induction motor nameplates: Analysis by using a finite element
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Design stimulation by software is important in order to save money and time. This paper is using stimulation software, which is a finite element method, to analyze the stator outside diameter impact on rated current, horse ...
The impacts of stator materials on induction motor nameplate parameters for high performance
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Core materials and magnet wire sizes were analyzed in order to find out the impacts on nameplate for high performance motor. Stack length and back core iron depth of stator geometry design are the parameters involve in ...
Fabrication and investigation of copper rotor bar on 0.5HP induction Motor-A performance and economical study
(Australian Journal of Basic and Applied Sciences, 2011-05)
The paper deals with the fabrication of copper rotor bars for 0.5HP induction motor and then comparing it with the existing aluminium rotor bars. From this experiment the rotors are compared in terms of efficiency increment ...
Performance of photovoltaic module at different tilt angles in Perlis, Northern Malaysia
(Praise Worthy Prize, 2010-12)
This paper presents a calculation of the tilt angles and the solar irradiance on PV module in Perlis, Nortern Malaysia. A mathematical modeling is used to calculate the tilt angles and the solar irradiance, which depend ...
Induction motor behavior due to unsymmetrical and symmetrical faults
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Voltage sags are generally caused by faults on transmission and/or distribution systems. The voltage produced may be either unsymmetrical or symmetrical, depend on type of faults. Unsymmetrical fault is faults caused by ...
Flux simulation on 100kVA three-phase transformer core
(Praise Worthy Prize S.r.l., 2010-06)
This paper describes the simulation of flux distribution on 100kVA 3 phase distribution transformer assembled with 60°-45° T-joint and mitred lap corner joint with stagger yoke and limb. The core that being used is 3% ...
In house construction of an induction motor rotor by using 0.35mm thickness of steel sheet for efficiency based investigation
(Trans Tech Publications, 2012)
In this paper, an in house production of a 0.5hp induction motor's rotor is investigated. This investigation considers the induction motor's efficiency and losses dissipation as an important aspect to determine the rotors ...
Different clamp stress impact on losses and flux distribution between two of 3 phase distribution transformer 1000 kVA assembled with stagger yoke of transformer core lamination
(Institute of Electrical and Electronics Engineers (IEEE), 2007-11-25)
The power loss of transformer core are depends on a large extent on mechanical stress. This paper describes the result of an investigation on effect different clamp stress of core lamination in the two of 3 phase distribution ...