Search
Now showing items 1-10 of 13
The effect of sintering temperature on mechanical properties of Al/SiC composites
(Praise Worthy Prize S.r.l., 2013)
This paper presents the investigation of the effect of sintering temperature on mechanical properties of Al/SiC composites. The composites were produced via conventional powder metallurgy processing. The particle size of ...
The corrosion studies of powder metallurgy Co-Cr-Mo (F-75) alloy
(AENSI Publisher All rights reserved, 2013-10)
Co-Cr-Mo (F-75) alloy was investigated for biomedical application due to its mechanical properties and good corrosion resistance. This study has been focusing on the corrosion behavior of PM Co-Cr-Mo alloy. The Co-Cr-Mo ...
Compaction optimization of Sn-Cu-Si3N4via powder metallurgy route for composite solder fabrication
(Trans Tech Publications, 2013)
The aim of this study was to optimize the compaction process of a composite solder fabricated via powder metallurgy route, before details study were conducted in the next stage. Powder of Sn, Cu and Si3N4 were carefully ...
The effect of sintering duration on mechanical properties of Al/SiC composites
(Praise Worthy Prize S.r.l., 2013-11)
Metal matrix composites (MMCs) have become attractive in a variety of applications due to its advantage of having intermediate properties between metal and ceramic. This paper presents the investigation of the effect of ...
A comparative study of solder properties of Sn-0.7Cu lead-free solder fabricated via the powder metallurgy and casting methods
(Syscom 18 SRL, 2013-07)
The properties of Sn-0.7Cu solder bulk prepared via the powder metallurgy (PM) method were investigated and compared with solder bulk fabricated through casting. Distinct microstructures were observed in both PM and casting ...
Microstructure and interface analysis of glass particulate reinforced aluminum matrix composite
(Trans Tech Publications (TTP), 2013)
A characterization of microstructure and interface was made on the composites Al- 4% Cu reinforced with 15 wt. % glass particulate. The composite was fabricated by powder metallurgy followed by solution treatment and ...
Fabrication and characterization of porous F-75 for potential application in tissue engineering
(Trans Tech Publications, 2013)
Porous F-75 (Co-Cr-Mo) was produced by powder metallurgy technique. F-75 powder was mixed with space holder and compacted using different pressures (300 MPa, 350 MPa, 400 MPa, 450 MPa). The green samples were sintered at ...
Effect of space holder and compaction pressure on the porosity of sintered copper
(Trans Tech Publications, 2013)
The effect of space-holder content on the porosity of sintered copper that was fabricated by powder metallurgy technique has been investigated. Carbamide was used as space-holder and the content selected was 10 wt. %, 20 ...
Development and characterization of Co-Cr-Mo (F-75 alloy)/hydroxyapatite composites fabricated by powder metallurgy for biomedical applications
(Universiti Malaysia Perlis (UniMAP), 2013)
Co-Cr-Mo (F-75) alloy is known to be used in biomedical field because of their excellent biocompatibility when implanted to human or animal body. Hydroxyapatite (HAP) powders have been used as filler because HAP is the one ...
Non-metal reinforced lead-free composite solder fabrication methods and its reinforcing effects to the suppression of intermetallic formation: short review
(Trans Tech Publications, 2013)
To increase the solder joint robustness, researches and studies on composite solder carried out by many researchers in an effort to develop viable lead-free solders which can replace the conventional lead-based solders. ...