Browsing Researchers by Title
Now showing items 2935-2954 of 3490
-
Simulation of cadmium telluride solar cells structure
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)A solar cell or photovoltaic cell is designed to convert sunlight into electrical energy through the photoelectric effect. Solar cells are the most attractive source to harness solar energy; it is not only has high efficiency, ... -
Simulation of crack analysis on a plate with ellipse and small rivet holes
(Universiti Malaysia Pahang (UMP), 2009-06-20)This paper is about simulation of crack analysis on a plate with ellipse and small rivet holes. This simulation is show the condition on a plate which has 8 rivet holes around the ellipse hole. This dimension of the plat ... -
Simulation of electromagnetic field (EM) focusing capability on biological tissue through the application of C-type excitation coil screen
(Institute of Electrical and Electronics Engineers (IEEE), 2012-02-27)In Magnetic Induction Tomography (MIT) or Electromagnetic Therapy system, excitation coil is applied with AC source in generating the electromagnetic (EM) field which then propagate and penetrate the object located in ... -
Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint
(Universiti Malaysia Perlis (UniMAP)Centre for Graduate Studies, 2010-10-16)This paper describes the result of simulation of flux distribution on 100kVA 3phase distribution transformer assembled with 23o T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The ... -
Simulation of nonholonomic trajectory for a car-like mobile platform using dubins shortest path model
(IEEE Conference Publications, 2011)Vehicles that move autonomously have received a good deal of attention where various top agencies have been the major sponsor of research in this field. Natural disaster such as earthquake, typhoon and tsunami would be ... -
Simulation of the two-phase liquid – gas flow through ultrasonic transceivers application in ultrasonic tomography
(International Frequency Sensor Association (IFSA), 2010-01-29)In this paper, ultrasonic transmission mode tomography was used to visualize the two phase liquid/gas flow in a pipe/vessel. The sensing element consists of 8, 16 and 32 units ultrasonic transceivers were used to cover ... -
Simulation on using cross-correlation technique for two-phase liquid/gas flow measurement for Ultrasonic Transmission Tomography
(Institute of Electrical and Electronics Engineers (IEEE), 2010-05-21)Combining Ultrasonic Transmission Tomography (UTT) with the cross-correlation flow measurement technique can provide more information on the flow than usual. A simulated dual-plane UTT system for use on laboratory and ... -
Simulation study on size and location identification of tumors in liver tissue through eddy current distribution analysis
(Institute of Electrical and Electronics Engineers (IEEE), 2012-02-27)In identifying the location of tumors in the liver, eddy current characteristics analysis can be applied since the conductivity value of normal tissue and tissue with tumors are different, which are 2.88 mS/cm and 5.33 ... -
Simulative study of two-phase homogenous and isotropic media imaging using magnetic induction tomography
(Penerbit UTM Press, 2014)Magnetic induction tomography is a new non-invasive technology, based on eddy current discovery of electromagnetic induction by Michael Faraday. Through this technique, the passive electrical properties distribution of an ... -
Simultaneous adsorption and biodegradation processes in sequencing batch reactor (SBR) for treating copper and cadmium-containing wastewater
(Elsevier Limited, 2002)The application of simultaneous adsorption and biodegradation processes in the same reactor is known to be effective in the removal of both biodegradable and non-biodegradable contaminants in various kinds of wastewater. ... -
Simultaneous extraction and separation of Cu(II), Zn(II), Fe(III) and Ni(II) by polystyrene microcapsules coated with Cyanex 272
(Elsevier B.V, 2009-02)The preparation of polystyrene microcapsules coated with Cyanex 272 (MC-Xs) have been investigated and simultaneous extraction and separation behavior of Cu(II), Zn(II), Fe(III) and Ni(II) in both batch and packed column ... -
Simultaneous localization and map building – a guided tour
(Universiti Malaysia Perlis, 2009-10-11)Simultaneous Localization and Mapping (SLAM) has been one of the active research areas in robotic community for the past decade of years. SLAM addresses the problem of a robot navigating and building a map of an ... -
Simultaneous removal of color, organic compounds and nutrients in azo dye-containing wastewater using up-flow constructed wetland
(Elsevier B.V., 2009-06-15)Combination of aerobic and anaerobic processes in constructed wetlands can enhance the treatment performance in textile wastewater. This study assessed the treatment of azo dye Acid Orange 7 (AO7) and nutrients using five ... -
Simultaneous wastewater treatment and power generation with innovative design of an upflow membrane-less microbial fuel cell
(Springer International Publishing, 2015-05-01)Abstract The objective of this study was to evaluate the performance of an upflow membrane-less microbial fuel cell (UFML MFC) with various types of carbon material as cathodes in power output and chemical oxygen demand ... -
Single trial motor imagery classification for a four state brain machine interface
(Institute of Electrical and Electronics Engineering (IEEE), 2009-03-06)Motor imagery is the mental simulation of a motor act which can be used to design brain machine interfaces [BMI]. A BMI is a digital communication system, which connects the human brain directly to an external device ... -
Single-crystal oxoborate (Pb 3O) 2(BO 3) 2WO 4: Growth and characterization
(Elsevier Ltd, 2012-09)An oxoborate, (Pb 3O) 2(BO 3) 2WO 4, has been prepared by solid-state reaction methods below 620°C. Single-crystal XRD analysis shows that it crystallizes in the orthorhombic group Cmcm with a = 18.480(4) , b = 6.3567(13) ... -
Sintering behavior and microstructure evolution of mechanically alloyed W–bronze composite powders by two-step ball milling process
(Elsevier, 2013-01)The miscibility of W in Sn and Cu is extremely poor. Sintering of W–bronze composites to their full density is proved to be difficult. To tackle this problem, the ball milling process of the W–bronze powder mixture proposed ... -
Sintering effects on mechanical properties of Co-HA composite prepared by modified electroless deposition.
(Trans Tech Publications, 2014)Co-HA composite produced using electroless deposition without conventional sensitization and activation treatment was studied with varying sintering temperature (1100°C, 1200°C and 1250°C). The particles size, bulk density, ... -
Site-specific evaluation of a MIMO channel capacity for multi-antenna mobile terminals in proximity to a human hand
(The European Association on Antennas and Propagation (EurAAP), 2011-04-10)This paper presents a comprehensive evaluation on the Multiple-Input Multiple-Output (MIMO) channel capacity performance of a coupling element -based multi-antenna structures on a mobile terminal at the 2000 MHz Universal ... -
Six thinking hats
(Kolej Universiti Kejuruteraan Utara Malaysia, 2004-12)