Search
Now showing items 1-10 of 44
Rainwater Catchment system – storage tank
(Universiti Malaysia Perlis, 2008-05)
Rainwater Catchment System is a system that collects rainfall from the catchment area and will be store in the water storage tank. This rainfall collection will be used as the
water sources for activities such cooking, ...
Design and fabrication of novel Articulated Robot Arm with mobile movement
(Universiti Malaysia Perlis, 2008-05)
This project had examined the Design and Fabrication of Novel Articulated Robot
Arm with Mobile Movement and Articulated Robot Arm that can perform for Pick and Place function. The project presents the processes undertaken ...
Design and development of Shredder machine for compost fertilizer production
(Universiti Malaysia Perlis, 2008-05)
Since years ago till now, the communities especially in Malaysia are not shows their interest in recycling activities and not get attention from them. For example, when we go to the market or any place that sell wet stuffs, ...
Design and analysis solar car chassis part
(Universiti Malaysia Perlis, 2008-05)
A solar car is a lightweight, low power vehicle designed and built with a single
purpose in mind – racing. They have limited seating (usually one, sometimes two people),
they have very little cargo capacity, and they can ...
To study a design of two and three-plate mould for injection moulding process
(Universiti Malaysia Perlis, 2008-04)
The purpose of this project to learn and practice design guideline for plastic
injection moulding process in design mould. There include to understand all the factor
that will affect the design product example poor design ...
The effect of pollution production in gas burner combustion system using Flat Vane Radial Air Swirler
(Universiti Malaysia Perlis, 2008-04)
A gas burner system with flat vane radial air swirler with vane angle of 20°, 40°
and 60° has been investigated to compare which swirler produce less Carbon Monoxide.
All tests were conducted using Butane gas. Fuel was ...
Stabilization of production rate for plastic products (Single CD) by using injection moulding machine
(Universiti Malaysia Perlis, 2008-04)
A researched project was designed in order to study the stabilization of production rate for plastic product (single CD) by using injection moulding machine. The study was carried out by identifying the operating parameters ...
Robust setting of Ti-6Al-4V machining using WEDM (High Energy with EF Circuit Off)
(Universiti Malaysia Perlis, 2008-04)
The purpose of this project are to optimize process variables of WEDM to obtain maximum MRR and minimum surface roughness in rough cutting. This project started with collecting the information from literature review regarding ...
Reusability of plastics
(Universiti Malaysia Perlis, 2008-05)
It is a challenge to reduce the ever-increasing flow of plastics waste. This study was undertaken to investigate the viability of recycling plastics products and their capabilities in substituting virgin plastics in the ...
Investigate the effect of cutting parameter pn Ti6Al4V surface in EDM wire-cut
(Universiti Malaysia Perlis, 2008-05)
Titanium aloy is aprovide exellent corrosion resistance, a high strength-to-weight-ratio
and good high temperature. It’s also have very high affinity to oxygen. A natural oxide
layer is always present on the surface. A ...